 |
| How to install your Pure Power! Lifetime Oil Filters |
1. Remove your current oil filter, then make sure the mounting surface is clean and free of any debris or gasket material. 2. The mounting surface of your block should be flat, with no grooves for )-rings, etc. The Pure Power! Lifetime Filter is designed with viton O-ring(s) fitted in the top of the oil filter mounting flange. 3. Fill the filter with oil from the top side of the filter. NOTE: If the filter mounts horizontally, DO NOT COMPLETELY WITH OIL. 4. Put a light coat of oil on the mounting surface of the O-ring(s). To install the filter, TIGHTEN BY HAND ONLY (NO TOOLS) approximately 3/4 to 1 turn after the O-ring makes contact with the engine surface. DO NOT OVER TIGHTEN, THERE WILL BE SOME SEPARATION BETWEEN THE MOUNTING FLANGE AND THE CANISTER. 5. Ensure that engine oil is installed, then start your engine and check for leaks. |
| How to service your Pure Power! Lifetime Oil Filter |
| You should inspect the stainless steel filter element at 500-1,000 miles for lint and debris. If the filter is clean you can extend your Filter service interval to every other oil change. If your filter shows more than 20 pieces of debris, clean, reinstall, and inspect again at 500-1,000. IMORTANT NOTE: CLEAN AND FLUSH THE FILTER ELEMENT AT LEAST 2 TIMES A YEAR! FLUSH THROUGHLY FROM INSIDE OUT. AIR CAN BE USED TO BLOW OUT THE ELEMENTS FROM THE INSIDE OUT. |
| How to inspect and clean your Pure Power! Lifetime Oil Filter. |
1. Place a drain pan beneath the filter. Remove the canister. Grasp the Stainless Steel Filter Element and rotate and pull down to slide it off the O-ring in the mounting flange, and then remove the bottom ByPass assembly or closure plate. 2. The element and the housing can now be cleaned in solvent, Clean biodegradable parts washer or hot soapy water. Wash element from inside out. The O-rings should be removed fro cleaning because some cleaners may be harmful to the O-rings. DO NOT USE BRAKE CLEANER OR CARBURETOR CLEANERS TO CLEAN O-RINGS. Hand wipe and inspect all O-rings and replace as necessary . 3. Rinse and if available, use compressed air to blow off any cleaning agents from your stainless filter element. Again, blow from inside out. Otherwise, shake and allow to completely dry before re-installing. 4. Hold your stainless mesh element to the light to ensure that it is completely clean. If it has particles, return to the wash area and clean again. Some debris may require multiple flushing to extract. |
| How to re-assemble your Pure Power! Lifetime Oil Filter. |
1. Begin by putting all O-rings back into place, then lube with clean oil. DO NOT TRY TO REASSEMBLE WITH OUT OIL ON THE THREADS OR O-RINGS. The stainless Mesh Element should be installed on the mounting cap first. The O-ring seal should be a snug fit. 2. Fill the filter with oil from the top side of the filter. NOTE: If the filter mounts horizontally, DO NOT COMPLETELY WITH OIL. 3. Put a light coat of oil on the mounting surface of the O-ring(s). To install the filter, TIGHTEN BY HAND ONLY (NO TOOLS) approximately 3/4 to 1 turn after the O-ring makes contact with the engine surface. DO NOT OVER TIGHTEN, THERE WILL BE SOME SEPARATION BETWEEN THE MOUNTING FLANGE AND THE CANISTER. 4. Ensure that engine oil is installed, then start your engine and check for leaks. |
|
||||||||